Mercedes-benz 2013 CLA Class Uživatelský manuál stáhnout pdf (Strana 210)

Useful information

i

This Owner's Manual describes all mod-

els, series and optional equipment for your

vehicle that were available at the time of

going to press. National variations are pos-

sible. Note that your vehicle may not be

equipped with all of the functions descri-

bed. This is also the case for systems and

functions relevant to safety.

i

Read the information on qualified special-

ist workshops: (Y page 24).

Important safety notes

G

WARNING

Operating the integrated information systems

and communications equipment in the vehicle

while driving will distract you from traffic con-

ditions. You could then lose control of the

vehicle. There is a risk of an accident.

Only operate these devices if road traffic con-

ditions permit. If you are unsure about the

surrounding conditions, pull over to a safe

location and make entries only while the vehi-

cle is stationary.

G

WARNING

If the instrument cluster has failed or mal-

functioned, you may not recognise function

restrictions relevant to safety. The operating

safety of your vehicle may be impaired. There

is a risk of an accident.

Drive on carefully. Have the vehicle checked

at a qualified specialist workshop immedi-

ately.

You must observe the legal requirements for

the country in which you are currently driving

when operating the on-board computer.

The on-board computer only shows messages

or warnings from certain systems in the mul-

tifunction display. You should therefore make

sure your vehicle is operating safely at all

times. Otherwise, a vehicle that is not oper-

ating safely may cause an accident.

For an overview, see the instrument panel

illustration (Y page 30).

Displays and operation

Instrument cluster lighting

The lighting in the instrument cluster, in the

displays and the controls in the vehicle inte-

rior can be adjusted using the brightness con-

trol knob.

The brightness control knob is on the bottom

left of the instrument cluster (Y page 30).

X

Turn the brightness control knob clockwise

or anti-clockwise.

If the light switch is set to Ã, T or

L, the brightness is dependant upon

the brightness of the ambient light.

i

The light sensor in the instrument cluster

automatically controls the brightness of

the multifunction display.

In daylight, the displays in the instrument

cluster are not illuminated.

Coolant temperature gauge

G

WARNING

If you open the bonnet while the engine is

overheating or while there is a fire in the

engine compartment, you could come into

contact with hot gases or other leaking

service products. There is a danger of injury.

Allow an overheating engine to cool down

before opening the bonnet. If there is a fire in

the engine compartment, leave the bonnet

closed and notify the fire brigade.

The coolant temperature gauge is in the

instrument cluster on the right-hand side.

Under normal operating conditions and with

the specified coolant level, the coolant tem-

perature may rise to 120 †.

208

Displays and operation

On-board computer and displays

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 351 352

Komentáře k této Příručce

Žádné komentáře